The kiln company talks about the solution to the excessive fire of the kiln:
I believe that this kind of kiln equipment and its use are familiar to everyone. It is a relatively common equipment for firing ceramics and other products. However, in the process of use, there will be a phenomenon of excessive fire in the kiln. So how do we solve this phenomenon in the face of the kiln? Let's take a closer look below.
1. When the fire is too fierce, we can adjust the density of the upper part of the billet stack appropriately according to the suction force of the kiln fan.
2. You can also ensure that most of the input coal falls to the bottom of the kiln when the stack is at the fire eye, and will stay in the upper part of the stack.
3. When the fire in the kiln is too fierce, we can raise the air gate, shorten the pre-heat zone properly, and lengthen the roasting zone.
4. When the fire is too large, you can also pull the fire through the near-draft gate and wait for the bottom fire to reach 3-4 rows of fire, then resume normal use of the gate.
5. The length of each belt of the kiln should be adjusted reasonably. It can also be improved by changing the Kang leg code method. The opening of the smoke gate can also be adjusted in time to increase the near gate appropriately and lower the far gate.
The content in the article introduces you in detail when the fire in the kiln is too fierce, what method should we use to solve it quickly and completely, because the appropriate temperature is very important for the quality of the finished product. When it is too high too low, it is likely to affect the burned products, even burn out. Unnecessary impact, therefore, everyone must pay attention to the control of the kiln temperature when using it in the future. I hope the content explained in the article will be helpful to everyone.
